Mediacom Digital Adapter Guia de preparacion descargar pdf (Pagina 8)

Optional: Connecting the IR Receiver

Programming the New Remote

You will need to install the IR Receiver if you cannot place

the Digital Adapter in a position that will be in clear view of your

remote or if you want to hide the Digital Adapter behind your TV.

Plug the smaller end of the IR Receiver into the

“IR In” port on the back of the Digital Adapter.

Place the other end of the IR Receiver where it can be seen

from the front of the TV. Use the adhesive fasteners in

the package to attach the IR Receiver to your TV.

This is the easiest method for programming your remote

control to operate the volume and power on your TV

and to change channels.

In this next section, you will use the remote to

automatically ﬁnd the right code for your TV.

Note: Please be careful. Mediacom is not responsible for any damage

done to any surface you stick these to.

Keys to successfully

programming your remote:

• Read all instructions carefully

before starting.

• Pay attention to the red light on

the remote after each step. You’ll

need to watch for blinks in order

to tell if you have completed a

step correctly.

• Be patient. It may take a few tries

to get this right.

• Step 4 is critical. Remember to

press and release “CH+” many

times but do it slowly and pay

attention. As soon as the TV turns

off, you’ll only have ﬁve seconds

to press the SET key to lock in

the code.

Red light

location

IR In

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Mediacom Digital Adapter Guia de preparacion Pagina 8